Step 1: Laser cut a frame, and lay out all the parts to make sure you have everything (thanks to TechShop I pieced the frame together in about a half hour).
Step 2: Piece the frame together so you are sure everything fits properly (I had to recut an entire sheet as my original cut outs for it where dimensionally innaccurate).
Step 3: Bolt everything together, viola, a frame!
Step 4: Wire Electronics
Step 5: Clean up the Electronics
Step 6: Show off the printer in Action
Step 7: Take over the world! ahem
No pictures yet, give me time for this one
